DW12 Printers with Commander
DW12 Printers with Commander
We've been dealing with printer issues at multiple sites, all with DW12 printers, some Red boards, some Jade boards. Seeing the post below and thought we should look at the basics again. Does anyone have the DW12s working without issues(outside of normal) with Commander? If so, what settings? From the post below I see NO to Zebra printer, NO to Tearbar printer, baud rate 115K. Anything else? The only option we've been given up to now is upgrade all printers.
-
- Head Tech
- Posts: 881
- Joined: Mon Apr 11, 2016 8:28 pm
Re: DW12 Printers with Commander
Had a site where they set the printers as tear bar and changed the printer baud rate. They did not consistently print.
Other than that have good luck with the settings mentioned below.
Other than that have good luck with the settings mentioned below.
-
- Head Tech
- Posts: 319
- Joined: Fri Jun 13, 2008 12:33 pm
Re: DW12 Printers with Commander
don't have too many issues with the DW12, the other setting is delayed printing that should be a no.
I can't fix stupid, But I can sure charge for it.
Re: DW12 Printers with Commander
Delayed printer is only for ARCOs with Retalixs
https://online.hillsdale.edu
Any society that would give up a little liberty to gain a little security will deserve neither and lose both.
Benjamin Franklin
Any society that would give up a little liberty to gain a little security will deserve neither and lose both.
Benjamin Franklin
-
- Head Tech
- Posts: 319
- Joined: Fri Jun 13, 2008 12:33 pm
Re: DW12 Printers with Commander
humm, never knew what it was there for, I just know the first time I saw it I set one pump as a yes to see what would happen, never set it again

I can't fix stupid, But I can sure charge for it.