Look here for answers to your technical questions. Post a question or share your expertise with others.
Post Reply
Posts: 4
Joined: Fri Jan 10, 2020 10:03 am


Post by GasMan97 » Mon May 18, 2020 9:27 am

Hello! I'm new to this coip thing and I need some help. I have a brcm2 with a 2 wire going to the dispenser. The dispenser has a Flex Pay IV card reader with a CCP board with no ssom or gsom it does have a board with the part number "M11071A001", I believe it is a dcm. I'm unsure what wires to use and where they go to. Is there a special wire to use with the 2 wire coming from the brcm2?

I am running passport with 12.02 generic.

Head Tech
Posts: 48
Joined: Sun Oct 08, 2017 5:58 pm


Post by Feaster33 » Fri May 22, 2020 12:03 pm

Sounds like you are ready to go. Are you a tech asking for help or an owner? You will need a managed network router, pumps will need tls certificates downloaded, set to ip mode, ip adressed, brcm will need moved from edh to router or switch, passport will need the ip's in forecourt. Check emv in the setup-fuel options in the managers work station.

Post Reply