Monochrome CPU Software

[merkfalc]

This is a dumb question, and pretty sure I know the answer. I'm getting "no resident graphics" message on the customer displays of an advantage with optimized electronics. I've already cold started and sent in new graphics from the ruby. I'm thinking the software on the board was erased when the board blew. The software that is in it is v. 15.1.10 but all I can find is 15.1.70. Will I run into any problems going with the newer version. Thanks for any help.

David

[ATLTech]

No problems. Your good to go with that version.

[merkfalc]

I figured as much. Thanks for the quick reply.

[DownSouth]

Might be worth checking the monochrome CPU battery.

[gdtaylor]

Speaking of the Monochrome CPU Battery --- Does Gilbarco have a document of any kind showing recommendations on replacement point for this battery ? every 2 years, 3 years, 5 years ? If they do, would one of you please send it to me ?

Thanks.

[shan]

Gerg
There is no document so for or at least I have not seen it regarding replacement of batteries but we normally check battries on logic bords and monochromme CPU bords if voltage is less than 3 volt it's time to replace battery

[merkfalc]

I made a habit carrying a few of those batteries just in case. This was the first time I've had to replace the software, but replace batteries a few times a year.